Bay Networks 5391 Guía de instalación Pagina 77
- Pagina / 138
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
3-19Remote Annex 6300 Hardware Installation Guide
Chapter 3 ROM Monitor Commands
image
The image command sets and displays the name of the image file
containing the Remote Annex 6300’s software. The syntax is:
image [–d | filename]
The filename argument permits up to 100 characters. To return the
image name to its default, enter a pair of double-quote characters ("").
The default image name is oper.63.enet. The image command display
looks like this:
The image –d command display looks like this:
The SELF image name appears only if the self-boot image is
loaded.
If the image file name contains more than 16 characters, it is
truncated when MOP is attempted.
monitor:: image
Enter Image name: [(ip)"oper.63.enet", \
(mop) "OPER_63_ENET.SYS"]::
Enter TFTP Load Directory [""]::
Enter TFTP Dump path/filename ["dump.192.9.200.88"]::
monitor:: image –d
Image name:Default (ip): "oper.63.enet"
Default (mop):"OPER_63_ENET.SYS"
TFTP Load Directory: ""
TFTP Dump path/filename: "dump.192.9.200.88"
SELF image name: "oper.63.enet"
- Remote Annex 1
- © 1996 Bay Networks, Inc 2
- Rules, Part 68 6
- Revision Level History 7
- Revision Level History 8
- Contents 9
- Contents 10
- About this Guide 15
- Printing Conventions 16
- Preface 17
- Convention: Represents: 17
- Related Documents 18
- Bay Networks Customer Service 19
- World Wide Web 21
- Customer Service FTP 22
- Support Source CD 22
- CompuServe 22
- InfoFACTS 23
- How to Get Help 24
- Remote Network Access 25
- Remote Annex 6300 Description 26
- Main Logic Board 26
- Modem Carrier Card 27
- Firmware and Software 27
- ROM Monitor 28
- Supported 28
- Configurations 28
- Watchdog Timer 28
- Front Panel 29
- Front Panel Components 30
- Network/Status 31
- (continued on next page) 31
- The button is used to: 32
- Rear Panel 33
- Rear Panel Components 34
- Physical Characteristics 35
- Before you Begin 37
- Front Mount 38
- (3 places each side) 39
- Rear Mount 40
- Bracket Mounting 41
- (2 Screws each side) 41
- Bracket Assembly 41
- (2 Screws, 2 Nuts, and 41
- 4 Washers each side) 41
- CONSOLE 10BASE5 10BASET 42
- ISDN PRI 42
- ❑ Thin Ethernet (10Base2) 43
- ❑ Thick Ethernet (10Base5) 43
- ❑ Twisted Pair (10BaseT) 43
- Ethernet cable (see 45
- Figure 2-7): 45
- Figure 2-8): 46
- Connecting a Console Terminal 47
- Annex 6300 49
- 2 Apply power 50
- 6300 to your LAN 53
- This section describes: 53
- 3 Execute the boot command 54
- BOOTP response with the sm 56
- Invoking the Console Monitor 58
- Command Descriptions 60
- Command Description Use 62
- Remote Annex 6300 is booted 72
- Remote Annex’s console port 73
- 6300 ROM Monitor commands 76
- Network test – PASSED 81
- [data bytes] [npackets] 84
- Statistic Description 87
- Bay Networks 89
- LED(s) Description 91
- Power-up and Boot Procedures 92
- N1: LEDs OK 93
- N2: Hardware OK 93
- NE2: Hardware Failure 94
- NE5: Booted wrong image 94
- Setup Mode 95
- T1: Testing LEDs 96
- T2: Testing Hardware 96
- T3: At Monitor Prompt 96
- TE2: Hardware Failure 97
- TE7: Booted Wrong Image 97
- Boot Failures 98
- Boot Error Report 99
- Error Description 100
- The broadcast address 101
- The subnet mask 101
- # /etc/erpcd –D5 103
- # boot -v 103
- Another Remote Annex 6300 104
- Remote Annex 6300 Dumps 105
- Annex overwrites crash dumps 106
- Console Port 109
- 10Base2 Ethernet Port 110
- 10Base5 Ethernet Port 111
- 10BaseT Ethernet Port 112
- PRI ISDN Interface 113
- Loopback Connectors 115
- Contents of the Kit 117
- Disassembly Instructions 118
- Installation Instructions 119
- Assembly Instructions 121
- Power-up and Test 122
- Removing Quad Modem Cards 131
- Modem Card 133
- DIP Switch S1 134
- Front of Unit 134
Relacionado con productos y manuales para Software Bay Networks 5391
Software Bay Networks BayRS Manual de usuario
(10 paginas)
(10 paginas)
Software Bay Networks 5000 Manual de servicio
(166 paginas)
(166 paginas)
Software Bay Networks 5391 Manual de servicio
(20 paginas)
(20 paginas)
Software Bay Networks Event Manager Especificaciones
(73 paginas)
(73 paginas)
Software Bay Networks Baystream 7 Manual de servicio
(382 paginas)
(382 paginas)
Software Bay Networks BayRS Manual de usuario
(24 paginas)
(24 paginas)
Software Bay Networks 5000 Especificaciones
(185 paginas)
(185 paginas)
Software Bay Networks BayRS Manual de usuario
(16 paginas)
(16 paginas)
Software Bay Networks Baystream 7 Guía de usuario
(162 paginas)
(162 paginas)
Software Bay Networks 4000 Guía de instalación
(162 paginas)
(162 paginas)
Software Bay Networks FastLink II Especificaciones
(47 paginas)
(47 paginas)
Software Bay Networks Radius Manual de usuario
(96 paginas)
(96 paginas)
Software Bay Networks BayRS Manual de servicio
(18 paginas)
(18 paginas)
Software Bay Networks Radius Manual de usuario
(14 paginas)
(14 paginas)
Software Bay Networks ATMSpeed Especificaciones
(74 paginas)
(74 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.043 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales