Bay Networks BayStack ARN Routers none Manual de servicio Pagina 111

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 156
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 110
Using Local Boot (the Quick-Start Procedure)
114200 Rev. A B-9
Enter OSPF interface type selection
[1]:
1. Broadcast
2. NBMA
3. Point-to-Point
4. Point-to-Multipoint (Proprietary)
5. Point-to-Multipoint (Per OSPF
Standard)
Note: When using a wide area
protocol other than Bay Networks
Proprietary PPP, we suggest
selecting NBMA.
Enter decimal value in seconds for
Hello Interval [10]:
Note: This value must match all other
interfaces in the OSPF area for
connection to take place.
The script suggests the following
intervals:
Broadcast -- 10 seconds
Point-to-Point -- 15 seconds
NBMA -- 20 seconds
Point-to-MultiPoint --10 seconds
Enter decimal value in seconds for
Router Dead Interval [40]:
Note: This value must match all other
interfaces in the OSPF area for
connection to take place.
The script suggests the following
intervals:
Broadcast -- 40 seconds
Point-to-Point -- 60 seconds
NBMA -- 80 seconds
Point-to-MultiPoint (STD) -- 40
seconds
Enter decimal value for Router Priority
[1]:
(For Broadcast, NBMA, or
Point-to-MultiPoint)
Enter a router priority value. The
lower the value (above zero), the
higher the priority.
Note: If you set the router priority
to zero (0), the router is not eligible
to become the designated router
on this network.
(continued)
OSPF Worksheet
(continued)
Requested Information Options Your Response
Vista de pagina 110
1 2 ... 106 107 108 109 110 111 112 113 114 115 116 ... 155 156

Comentarios a estos manuales

Sin comentarios