Bay Networks CM 100 Manual de instrucciones descargar pdf (Pagina 53)

Installation

893-00992-A 2-5

Installing the BayStack 350T Switch

This section explains how to install, power up, and verify the operation of the

BayStack 350T switch. Before you begin these procedures, read and follow the

instructions in “

Site Preparation” on page 2-3.

The BayStack 350T switch can be installed in any of the following locations:

• Surface mount

— Tabletop or shelf (secured or unsecured)

— Wall mount

• Rack mount—19-inch equipment rack

Surface Mounting

The BayStack 350T switch can be surface mounted onto any appropriate surface

that can safely support the weight of the switch and attached cables, as long as

there is adequate space around the unit for ventilation and access to cable

connectors. Mounting brackets supplied with the switch allow you to secure the

BayStack 350T switch to the installation location.

Warning: To avoid bodily injury from hazardous electrical current, do not

connect the power cord until instructed to do so.

Note: In most cases it is not necessary to secure the BayStack 350T switch

onto a tabletop or shelf. However, if conditions warrant securing the switch,

such as when installing the switch at locations that are subject to heavy trafﬁc

or at overhead locations, you can secure the BayStack 350T switch with two

mounting brackets (supplied).

BOOK.MKR Page 5 Tuesday, March 4, 1997 7:24 PM

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 139 140

Sin comentarios

Bay Networks CM 100 Manual de instrucciones Pagina 53