Bay Networks ATMSpeed Especificaciones descargar pdf (Pagina 37)

9031561 E1 Conﬁguration Views

3-9

ATM Conﬁguration

ATM Port

Number of Endpoints

Number of endpoints in the circuit. An endpoint is deﬁned as a combination of

card/port/vpi/vci.

Endpoint List

List of endpoints for the circuit. Each endpoint includes:

• Card (32 bit)

• Port (32 bit)

• Vpi (32 bit)

• Vci (32 bit)

Status

The current status of the entry. Entries may be added by specifying a value of

valid, and removed by entering invalid.

ATM Port

Within this view is the ATM Port Table view which contains the following

information:

Card

This ﬁeld indicates the ATM card id.

Port

This ﬁeld indicates the ATM port id.

Enable

This ﬁeld indicates if the ATM port is enabled or disabled. 1 = enable and 2 =

disable. When the port is disabled no cell trafﬁc will be generated or accepted

and no SONET signal is generated.

Loop Timing

This ﬁeld indicates whether loop timing is enabled. 1 = enabled and 2 =

disabled.

HEC Coset

This ﬁeld indicates whether HECCoset (Header Error Check) is enabled or

disabled. 1 = enabled and 2 = disabled. When the port is disabled a SONET

signal will not be generated and cell trafﬁc will not be generated or accepted.

HEC Correction

This ﬁeld indicates whether HEC is enabled or disabled. 1 = enabled and 2 =

disabled.

Frame Mode

This ﬁeld indicates whether the frame mode is SONET, SDH or notApply (no

cable plugged in).

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 73 74

Sin comentarios

Bay Networks ATMSpeed Especificaciones Pagina 37