Bay Networks Remote Annex Guía de instalación descargar pdf (Pagina 46)

Nortel Networks 5399 Access Switch Hardware Installation Guide

Chapter 2 Installing the Model 5399 Remote Access Concentrator Module

2-14

Connecting a Service Port Terminal

If your network does not include a BOOTP or RARP server, you must

connect a terminal to the service port on the System 5000 chassis front

panel and manually configure the Remote Access Concentrator before

booting.

ToconfiguretheRemoteAccessConcentratorthroughthechassisservice

port, you need:

• An ascii terminal or a portable computer with a serial port

and the ability to emulate an ascii terminal. The terminal

should be set up for:

– 9600 bps (default)

– 8 data bits

– No parity

– 1 stop bit

– No flow control

–ASCII

• An RS-232 modem cable with a female DB-9 connector to

connect to the service port on the chassis front panel. The

other end of the cable must have a connector appropriate to

the serial port on your computer or terminal. (Most terminals

or computers use a male DB-9 or DB-25 connector.) The

cable should use the pin assignments in Table 2-3

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 125 126

Sin comentarios

Bay Networks Remote Annex Guía de instalación Pagina 46