Bay Networks Remote Annex Guía de instalación descargar pdf (Pagina 63)

2-31

Chapter 2 Installing the Model 5399 Remote Access Concentrator Module

Nortel Networks 5399 Access Switch Hardware Installation Guide

Self-booting the Remote Access Concentrator

The Remote Access Concentrator comes equipped with Flash memory

that contains an operational image you can use to self-boot the module.

To self-boot your Remote Access Concentrator, perform the following

steps:

1. Initialize the IP address parameters using the manual

initialize method.

The manual initialization method is described in “

Manually

Initializing the IP Address Parameters”onpage2-26.

2. Enter the sequence command at the monitor prompt.

The following prompt is displayed:

Enter interface sequence [net]::

3. Enter self, net as the sequence.

The monitor prompt is displayed.

4. Enter the boot command at the monitor prompt.

The display looks similar to this:

monitor:: boot

Waiting for CMB Config Block Info...

Requesting default boot file “OPER_64_ENET.SYS” for

MOP/VMS\ loads and “oper.64.enet” for all other

protocols. Unanswered requests shown as ‘?’,

transmission errors as ‘*’.

Booting file: “OPER_64_ENET.SYS” from SELF

Loading image from SELF ...

.................................................

Load Completed

The self-boot takes 10 seconds to complete. Once the Remote

Access Concentrator has booted, Monitor Mode is no longer

active.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 125 126

Sin comentarios

Bay Networks Remote Annex Guía de instalación Pagina 63