Bay Networks Remote Annex Guía de instalación descargar pdf (Pagina 78)

Nortel Networks 5399 Access Switch Hardware Installation Guide

Chapter 3 ROM Monitor Commands

3-12

The boot –l command downloads and saves the operational image to

RAM,erasestheexistingFlashmemory,copiesthenewimagefromRAM

to Flash memory in compressed form, and then executes the image.

The boot –l command display looks similar to this:

After executing a boot –l,thels command may not show the

newly-loaded image. If this happens, the image is not stored in

Flash memory. This indicates that you could have a problem

with your Flash memory.

monitor:: boot –l

Enter boot file name [(ip) “oper.64.enet”, \

(mop) “OPER_64_ENET.SYS”]::

Waiting for CMB Config Block Info...

Requesting default boot file “OPER_64_ENET.SYS” for \

MOP/VMS loads and “oper.64.enet” for all other protocols.\

Unanswered requests shown as ‘?’,transmission errors as‘*’.

Requesting boot from 192.9.200.88 via Ethernet...

Booting BFS file using open delay of 8

Booting from 192.9.200.88

Header received OK. Received data blocks shown as ‘.’.

.............................

..............................

....................EOF

Saving image into storage device ...

Erasing device

|-----------------------------------------------------|

.......................................................

Erase completed

Storing image ...

......................................

Storage completed

Beginning execution of image...

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 125 126

Sin comentarios

Bay Networks Remote Annex Guía de instalación Pagina 78