Bay Networks Remote Annex Manual de usuario descargar pdf (Pagina 14)

Configuring the Nortel Networks Remote Access Concentrators and the DMS-10 for Remote Access.March 31, 1999 14

FIGURE 6. Overview of the Monitor structure

Monitor Entry

Rotary

Super User

CLI

“SU”

Administraton

Telnet

Entry Point

Serial Port

Entry Point

Type “CLI”

Type

“ADMIN”

Password=

Note*3 :The initial password for super User is the ipaddress

assigned initially. It should be changed.

ROM Monitor

Functions

addr -configure the Ethernet interface ip setup

sequence -display and edit the boot interface sequence

Type “CLI”

CLI

Functions

monitor::

info - show configuration information for server

reboot - reboot the server

rom - return to ROM monitor

pingsend -ICMP ECHO_REQUEST, host

configshow -hardware configuration and rev info

stats -display network error statistics

erase -erase non-volatile memory

quit - quit back to quiet console

syslog - show last syslog message

annex:

history :Display history of previous commands

netstat :Display network statistics

stats :Display Annex statistics

telnet :Connect to host using TELNET protocol

who :Show Annex users

hangup :Hangup and reset an Annex port

Console monitor:

cli - start CLI

annex#

admin :Enters local administration function

boot :Reboot or force Annex dump

hangup :Hangup and reset an Annex port

history :Display history of previous commands

hosts :Display/modify hosts/name servers

modem :Displays configured modems

netstat :Display network statistics

passwd :Change Annex password

route :Modify the active routing table

stats :Display or Clear Annex statistics

stty :Show/Set Annex port parameters

telnet :Connect to host using TELNET protocol

wan :Show/set WAN Interface data

who :Show Annex users

su :Enter or exit administrative mode

su :Enter the administrative mode

admin : ?

help or ?: display this help screen

broadcast: send a broadcast message to a port or ports

modem: enter default modem set

interface: enter default interface set

quit: terminate administration

reset: reset a port, interface or subsystem

show: display the current value of an eeprom parameter

set: modify the value of an eeprom parameter

Note*1 : If VCLI security is set a username and

Note*2 : If CLI security is set ausername and

Note*1

Note*2

Type “ROM”

9600 baud

8 bit no parity

password will be required.

“ip adress”*2

Point

“boot”

“hangup”

“quit”

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 37 38

Comentarios a estos manuales

Sin comentarios

Bay Networks Remote Annex Manual de usuario Pagina 14

Comentarios a estos manuales

Relacionado con productos y manuales para Software Bay Networks Remote Annex