
Configuring the Nortel Networks Remote Access Concentrators and the DMS-10 for Remote Access.March 31, 1999 36
If you are interested in more that the current 15 minute interval the stats -T all command is
useful. This command will display 96 15 minute blocks to the console screen, indicating
the WAN status for the last 24 hours. Below is an abbreviated example:
WAN Interface 1:
Alarm History:
time unknown
NO SYNC
Current Alarms:
Circuit ID:
T1 info:
Loopback mode: no loopback
Current Statistics:
time unknown
Number of valid seconds: 249
Errored Seconds: 0
Severely Errored Seconds: 0
Bursty Errored Seconds(ESF only): 0
Unavailable Seconds: 0
Controlled Slip Seconds: 0
CRC6 Error Event(ESF only): 0
ESF Error Event(ESF only): 50
Severely Errored Framing Event: 0
Frame Sync Bit Error Event: 0
Out of Frame: 0
Loss of Frame Count: 0
Line Code Violation Event(BPV): 0
Controlled Slip Event: 0
Unavailable Signal State: Clear
Interval # 0 Statistics:
time unknown
Number of valid seconds: 900
Errored Seconds: 0
Severely Errored Seconds: 0
Bursty Errored Seconds(ESF only): 0
Unavailable Seconds: 0
Controlled Slip Seconds: 0
CRC6 Error Event(ESF only): 0
ESF Error Event(ESF only): 50
Severely Errored Framing Event: 0
Frame Sync Bit Error Event: 0
Out of Frame: 0
Loss of Frame Count: 0
Line Code Violation Event(BPV): 0
Comentarios a estos manuales