Bay Networks Remote Annex Manual de usuario descargar pdf (Pagina 15)

Configuring the Nortel Networks Remote Access Concentrators and the DMS-10 for Remote Access.March 31, 1999 15

A typical command would be “show port all”. This command will show all the port set-

tings.

Annex commands deal with generic system items such as:

• IP addresses

• CLI and VCLI parameters

• Name Servers

• Security

• Event Logging

• Routing

• SNMP Maintenance

Wan of course deals with the two T1 based WAN’s. In the WAN section the T1 character-

istics are set up along with B channel parameters.

Following any changes it is necessary to reset the device or in some cases boot the RAC to

make the parameter change take effect.

5.5.2 Setting the Initial Parameters.

The initial parameters are set using the Console monitor in the ROM monitor portion or

the RAC. This information is covered in the publication “Installing the Model 8000

Remote Access Concentrator”. This document covers setting the RAC into its initial setup

mode, it also covers the requirements for the IP addresses and supplementary information.

Figure 7 gives a view of the parameters and their significance.

FIGURE 7. Initial Address Setup

monitor:: addr

Enter Subnet mask [255.255.255.0]::

Enter Internet address [<uninitialized>]:: 47.39.240.40

Internet address 47.39.240.40

Enter Broadcast address [0.0.0.0]:: 47.39.240.00

Broadcast address 47.39.240.00

Enter Preferred Load Host address [<any host>]:: 47.39.240.99

Preferred Load Host address 47.39.240.99

Enter Preferred Dump Host address [0.0.0.0]:: 47.39.240.99

Enter Preferred Dump Host address 47.39.240.99

Enter Load/Dump Gateway address [<uninitialized>]:: 47.39.240.1

Enter Load/Dump Gateway address 47.39.240.99

Select type of IP packet encapsulation (ieee802/ethernet)

[<ethernet>]::

Load Broadcast Y/N [Y]::

This value sets the IP address the RAC will use for it’s connection

This value is the submet mask for the subnet the RAC is on.

This address is address the RAC uses to communicate with a security

of file server.

This is the address of the file server which serves as the load file

host for the RAC.

This is the address of the file server which serves as the dump file

host for the RAC.

Gateway address for the RAC. Serves as a route as well as a gateway

it the RAC’s file server is on a different subnet.

Setting up the initial addresses in the ROM monitor

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 37 38

Comentarios a estos manuales

Sin comentarios

Bay Networks Remote Annex Manual de usuario Pagina 15

Comentarios a estos manuales

Relacionado con productos y manuales para Software Bay Networks Remote Annex